• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by suhy_pl

  1. is it possible... convert anapurna m 1600 CMYK LcLm to white?

    hi im looking for uv flatbed/hybrid printer with white and quality /km or ricoh printheads/, but prices... /for my business....ehh/ so, its possible to convert agfa anapurna m1600 CMYK LcLm to CMYK W(W)? is it technically possible? at the moment i've got a few japan mild/eco/solvent printers...
  2. firmware cg-130 fx

    tx in advance, will wait... thanks
  3. firmware cg-130 fx

    hi Im looking for last firmware and updater for cg130-fx cutter (not FX II) it is probably 3. XX version, will aprecite any help... tx tom
  4. Looking for csv file from working JV34-260...

    hi Im looking for csv fie from working JV34-260...urgently Thanks in advane Tom
  5. jv34-260 firmware problem..

    Thanks Rich Thanks Rich :rock-n-roll:
  6. jv34-260 firmware problem..

    Hi All I've got a problem with jv34 - this printer comes from showroom to my printhouse, and its an early version from 2011, sometimes hung up and some prog's errors occured (with mem addresses) but works after restarting... on friday F-ROM error was occured, and after restart F/W UPDATING...
  7. how to get/put new firmware for JV33

    Ok, Ive got new printhead installed, I need to update instruction posted by BoF... 1. You need to have small (short) philips X screwdriver... to unscrew 2 back screws. 2. More difficult problem is put back head cables (ribbons) you need to use some force to do this.... Another thing is - my...
  8. JV3 error

    Before you replace expensive PCBs... First you need to check firewire card in your PC, or replace it (the best is with Texas Instruments main chip... its not expensive) also check firewire cabel... While checking this - please switch off both - computer and printer, this is very important...
  9. jv3 - came in this morning and it is still on?

    hi We have the same, its because the cleaning procedure was interrupt by the wiper fault (probably wiper didnt return to home position or something else -printhead hit it?), after this - cleaning procedure is not finished and ploter not going for standby mode. tom.
  10. how to get/put new firmware for JV33

    Thanks a lot BoF, Another question - I dont know what about dampers - will I change it too? How to check the damper? Take it off, and start fill up? This machine stays for long term - couple of months. tom
  11. how to get/put new firmware for JV33

    Hello everyone, Im are looking for new firmware for JV33-130 and software for upgrade it. I've got already v 1.3 and has a problem to extend expiry date of cartridges... Also I need exchange printhead, and have no idea how to do this. If someone has service manual or just head replacement...
Top