Recent content by Tazman00

I use SignCut with Corel X3 and X4, works fine with no problems at all.

Thanks for the the tips! I'll give them a try. Shovel, I tried that macro and couldn't get it to work! Thanks again!

Can anyone tell me how to convert an object to path in Corel X3 or X4. I'm trying to make a checker pattern curve around a bike fender, like in the pic attached. Any help is appreciated!

I have a Copam CP-2500 and use Corel X3 and Signcut X2. I use inches in Corel when I design, and have Signcut set to inches as described in my above post. I've never had a problem with it cutting the wrong size. and haven't set any settings on my cutter for inches or mm's. Taz

To change mm's to inche's in signcut X2, go to settings at the drop down go to settings again change unit: to inch and area unit: to sqinch. Taz

In Corel X3 go to text tab, then fit text to path. drag your text over your object.

guess not don't see your cutter in the list

will this work? http://www.flexiezine.com/article.php/Flexisign75to76update

can't hurt to try....hope it works for you! :thumb:

that's strange flexi should have found the drivers... are you using serial or parallel?

did you try rebooting your pc after installing the drivers? that might help.

didn't it come with a driver disc? or go to graphtecs website and download the driver.

Thanks again Shovelhead!!

Thanks!! :thumb: