Recent content by TD Digital

Do you have something that is a known thickness? Like a 1/4 inch acrylic? Place in each corner and press remote. Deviation should be less than .1 mm in each corner If it drops all the way the optical sensor is so misaligned it's seeing the table or carriage.

I am certified on the old UJF models and have rebuilt many of them in the past. Currently run production on a 3042-HG that I rebuilt from the ground up. Search my build on this page. I can offer remote support if you're still looking $250 to start for 2 hours remote

Digiprint supplies and Alibaba have less than A grade printheads. Nothing wrong with them but they are not perfect and may have some minor jetting issues. I have several Gen5 available direct from Ricoh if anyone needs the Gen 5

6 Brand new Ricoh Gen 5 heads Looking for 10 brand new Ricoh Gen 4 printheads. Located Charlotte NC.

Parts from Inkcups are highly marked up. I'll sell my new gen5 heads cheap if anyone's looking

Is the X2 gen5 or gen4 heads? I have a half dozen gen5 from a left over build and I may and try to get my hands on an X2 or Xjet I need if repair

I have Gen5 heads available if needed. Brand new never opened. $1600 each or $1500 if you buy 2.

I have one available. Shoot me a PM. They are still pricey, but definitely not $2400

I would look at your damper first.

You either have an issue with the hot water heater or the pump. If the tech who installed the machine didn't prime the pump prior to turning it on that can put tremendous stress on the pump itself. If you constantly get the head temp please wait and you are certain that there isn't an over...

Hello Everyone, If you have any old, dead or dying UJF-3042 or UJF-6042 machines post below. I'm always looking for spare parts or a clean rebuild. Thanks,

Thanks for all the feedback! The 3042-HG is in full production and is one of our go-to machines for production. I have about 4-5K in parts/heads. I don't use the OEM Mimaki head assembly because it costs so much so I source my heads separately and then purchase the damper and damper adapter...

Who was your dealer? I have worked for a Mimaki dealer for years and if we ever had a machine with these issues we would send the unit back. I'm assuming you bought from a smaller mom/pop dealer because any reputable dealer would have made it right.

Hello Abrham, I recommend purchasing two flushing cartridges and that you flush the white system completely. You may also need to change the dampers because that black pigment is extremely difficult to get rid of completely.

I was able to change the parameters. Thanks