I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
ok are your dampers compressing when you do a fill up and is your cap top sucking the inks through properly if you have a cap top i suggest you change it and see if that works if not there are a couple of things you can do but you have to be hands on person with the printer cause what i would...
i am having some trouble with my jv 33 prints it is printing off the media and i have to shift the prints in the software so that it prints in the position is there a way to set the margin
i have had this problem many times it seems ,that if your cartridges run empty and the machine ,keep trying to get ink from it ,it will get air in the lines and will not let the ink pass through so you will have to manually prime the dampers till the air comes out the quickest way is to use a...
i would go with the mimaki the uv works great on wraps and outdoor signs no need for laminate will cost you less and there are a lot of good third party inks out there that is cheap but you need to look at the after service for your printer as someone said look for a dealer that is close to you...
ok just to let you
just to let you know i figured out my problem it was my power supply it was reading 2.3 on one of the pins that should be reading 3.3v that is needed for some of the relays and transistor and chips to work properly so my main board was just powering up half way and when the...
hi i change the slider board and the machine boot up and then it turned off and went to boot and nothing is happening i turned it off via main switch and back on again and the panel screen has nothing showing on it
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.