Recent content by tomcnc

I want to thank you for all the help and very grateful. now i just need to set cutter just for Kisscut and perf cut only that all i need to just get setting the right way i have other cutter just for vinyl.

I just got the new push down and up OPOS hey video but my counter cutting is off

I was wondering if I can downgrade the firmware it ha rev .028

There is only one that’s on right side

now i need to get setting right again what i did was bring down the OPOS start the barcode read then it lifts the sensor up does the cuts again

I try to get better video for you Thank you for helping out on this I am so Grateful.and yes I calibrated the OPOS cut square then I weed it will read and no error’s

Got that done the serial number now my OPOS not reading just doing circle around black box I try OPOS print on paper Send to cutter with cutter control Line up one top of the black box with the tool it just goes in circles I do have video

I did everything I can my OPOS was reading alittle and miss cutting I did all the trouble shooting before I update.so I update to the newest firmware M9985-.040 now my serial number is not listed on the fw version and not on cutter control. Can anybody help with this I think my machine not...

Yea I thinking on just taking the bite of buying new original encoder strip but no time soon

ok i just notice when i do scan axis test it says its going to move cartridge to the middle but it dont it move just alittle from the left side how do i re calibrate scan axis i am in the service menu but i dont see it at all

Ok Did PCA test it pass Line sensor pass Paper jam test pass Scan axis fail again I going try keep adjusting the rubber parts to see it one pass first one fail still. I going try get a new encoder strip try for the original one but dont know if I should put more money into it.i still will need...

Hi I am new here. I have a l25500 put in a new cartridge and belt both are original hp and encoder strip is a China one. Ok I boot printer up it loading the cartridge move to right then when it goes to the lefted it gives me error 86:01. But when I do the scan axis test it give me this error...