Recent content by tommythesignguy

I have one similar to this above my desk.

I've done some repairs on sign cabinets where I didn't have this tool and used a metal hole saw. Turn it at an angle where it cuts three quarters of the hole. score the straight edge and then break off the tab.

I went with the 2017 version which fixed some of the bugs in X8. I had X5 but had issues with windows 10. It is much, much faster.

Not a type font. The "C"s are not the same

like the logo said: "All kinds of easier!"

My printer keeps cancelling the print in the middle of a job. Never in the same place. Any ideas as to why? I have several high end wraps going and can't simply seam them every time the printer decides to take a break.

I have x5 but will upgrade and try it. Thanks so much!

I have used corel since it was corel 3, so I'm pretty familiar with it. I have 25 different sized tables (some square some rectangular) that I have to set up to place 18 ads on every one of the various tables. Is there a quick way to place all of the individual ads in a pile in the middle and...

Signs 101 Network RegistryIn what country are you located? USA In what state or province are you located? Alabama In what city or town are you located? Gadsden What large city is nearest you? Birmingham Check all items that apply to your listingInstallations (Basic, no permits)...

I have a project where I have a monument sign a good distance from the power source of the buildings. I plan to back-light a flat cut acrylic logo with LED lighting. Is there a solar panel that will generate power for this sign that will eliminate the need for conduit being run out to the monument?

xxx

I currently own and operate a small sign business in Alabama. I have over 25 years of experience in all aspects of the industry including wraps, electrical, neon, - manufacturing and installation, etc., I am an accomplished artist/designer (especially Corel) and have extensive printing...

Thanks to all for any input on getting my 1324 back up and running. Mutoh next day aired me a transistor board that took all of 5 minutes to install. I downloaded some firmware from their FTP site and I am back up and running! It's a great feeling when things go this smoothly instead of the...

Well, contacted Mutoh. Attempted to reload firmware and a .mlf file with no luck. the second file would not take so they are sending me out (next day) some type of circuit board. I may have to wait for a tech to come install it. Just glad it is under warranty although it is costing me down time.