Recent content by wakeshredder

I have the firmware, 2.8 I believe at home. As well, I have the correct software for updating it. I will try and send it to you tonight. I should tell you, if you call Mimaki USA in Georgia, they will walk you through the update. They will use Team Viewer and do the whole thing for you if you...

So, the two rollers that my vinyl media rides on behind my machine need help. Each of the rollers has a broken bearing on the end. The bearing are screwed in to the rollers. They are 26mm OD, with an M6 stud. I've tried like hell to find one online with no real luck. I bought the machine from a...

Mo have the exact same problem. Same cutter. I tried your solution but it still has the same error. Can you tell me who you caled? Did you have to change anything else? Any help greatly appreciated.

Also, I meant to tell you that I fixed my "lazy solenoid" issue. It was actually the rubber bumper that had an indent in it from years of plotting. After each plot, if the head bumper would sort of stick. I added a small piece of felt and voile!

FrankW, do you know where I can get a white light sensor for my cutter?

FrankW It's a SummuCut D120se Older for sure, maybe 2004 or 2005. It's a drag head.

FrankW I cannot even begin to tell you how immensely grateful I am for your solution. It worked right away. I couldn't believe that I was unable to find anything close to a solution online or in a manual. You have reinforced to me the significance of forums like these. I wish I could buy you a...

Jim, I have the same problem described in this thread. Can you tell me how to restore "factory-default settings" via Summa Cutter Control. I have the software, and I have even updated the firmware to no solution... Thank you for anything you can share!

I have an L25500 that needs the rewinder motor gears replaced. Someone pulled the spindle out from the left side only and it broke the plastic piece that holds the rewinder gear which connects to the spindle. That gear is metal with a plastic gear connected to it that is driven by the rewinder...

I need a functional rip, preferably Onyx 7-10 or any RIP that can drive my L25500. I have ProfileMaker 5, so I don't have to have the ICC profiling module. Please PM me if you have something for sale.