• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by wetcoastsignman

  1.

    363TH Laminator wrinkling jobs

    Will have to check how much force is needed to pull through the rollers. This job was run through with the feed (set right between 2 & 3), not pulled through. We store with the rollers up, and as far as we can tell, the media isn't touching the laminate before going through the rollers...
  2.

    363TH Laminator wrinkling jobs

    Yes, I do believe it is generally in the middle.... will have to try backing off on the pressure, but I'm only going until the crank stops and then not even another 1/16 of a turn....
  3.

    363TH Laminator wrinkling jobs

    Hello all, We are about ready to drop our laminator off the edge of a cliff into the ocean! About half the time the laminator works fine, but then the other half of the time we get wrinkling in the media parallel to the rollers, and it is almost always in the last half to last quarter of the...
See more
Top