Recent content by WorxMedia

these look legit! thank you!!

Hello All! I’m having trouble finding this type of bracket so that we can install some parking signs into a concrete base for a shopping center. Anyone know where this type of hardware can be purchased? Any feedback would be greatly appreciated.

My machine was having the same issue (VS-540). I updated the firmware and everything appears to be working fine again. Im halfway through a print now and the heads haven't cleaned during. Keeping my fingers crossed. I appreciate the help!

Thank you so much!!

Hello Mr. Bert! Would you still have a copy of the service manual for the VS540. If you can send the link that would be greatly appreciated! Thank you for your help.

I agree, if youve worked with 180 and installed with IJ35c you would definitely be able to tell a difference, regardless of installing on a flat or contoured surface.

Hello All! My mainboard on my VP540 went out and I am in search of the peck software so I can grab parameters on my existing board and replace. Ive already downloaded the copeck software from the Roland site, but its not letting me grab the parameters. If anyone can point me in the right...

Have a client wanting to apply their company logo on some plastic textured lockers that are outdoors. Has some kind of slick teflon coating on it. I did an adhesion test and applied some oracal 751 with some primer 94 and heat with no luck. Any suggestions?

Have you ever done a wrap removal like this? Im just wondering since I have not but here is my math/ logic. 5 Gallon bucket of Rapid Remover - $250 1 week Rental of machine - $600 1 work week (5days) of hired help 3 guys @ $15 per hour/8hour days - $1800 Lunch - $250 Total is $2900 cost...

Lol! I just removed a very small section that was already lifting up and it wasnt too difficult to pull off. Thats not to say the whole thing will be like that. I did see that literally every rivet was tented and when I grabbed my plastic scraper and went around it the vinyl was very brittle...

Here are some pics of the wrap. It will deff have to come off. Wrapping on top is not going to work. closeups My plan is to rent a high powered gas 3500hp Hot Water pressure washer to do the initial removal and some good old fashioned rapid remover and plastic scrapers for any left over...

Not sure what the condition of the current wrap is. Doing a site survey this Tuesday. If its not cracking then I will consider wrapping on top, with the disclaimer that the work will not be warrantied. I came across this method while doing more research. What do you guys think about doing...

I dont think what they are using is methylene. They have no face mask on as they are spraying it and they are using their bare hands to pull it off. On the video it says its a mixture of bio-degradable chemicals. Im going to mix rapid remover with something and try to come up with my own...

I called and left numerous voice mail messages and no response. I dont think they want to share their "secret recipe". I thought sharing is caring. They would make bank selling that stuff haha.

We have a client that is wanting to rewrap their 18 wheeler box truck. We will have to remove the wrap that has been on the trailer for at least 10yrs (woohoo). My normal "go-to" to removal is using a heat gun/torch and rapid remover for any residual adhesive. For larger areas I will use a...