I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Ok so swapping around cables and pulling ink through with a syringe has gotten me to the following results:
1. Ink pulls through cap tops without issue
2. After putting everything back to where it was originally, I am only getting M & Y to print.
3. If I swap the cables again, only C will...
Thank you for the suggestion. I did as you instructed and when running a test print, nothing printed at all, when I swapped the cables back, just M and Y printed. Am I screwed?
Hey everyone,
I have been troubleshooting, repairing, and replacing parts on our SP300V for about 2 weeks and I'm to a point where I'm stuck.
1. Originally our black (K) stopped printing completely, and I noticed that the manifold for the print head had somehow snapped so ink suction wasn't...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.