Separate names with a comma.
Bulk Ink System
Mutoh makes a bulk ink system for your machine but I have not played with one yet outside of checking out parts and pieces at...
I had a customer with the same issue recently. I replaced the junction board and the reader board. Quick and easy took care of all issues. Plus...
Check the position of your registration marks. Measure to make sure they are in the right place on the print. This is where I would start. That...
Northern Tool& Equipment sells them. Not bad pricing either but remember sometimes you get what you pay for.
Olfa makes a liner cutting tool that works great. I would be willing to bet there are several MM here who carry them.
Sounds like maybe you need to do a PF adjust.
3M General Purpose Adhesive Remover. Have used it for years and it works great for everything I have used it on.
We are working on this same issue with a customer in MN. Keep me posted on any fix. Sounds like the exact same issue. If I find the answer...
You replaced the heads? I would check the head cables to make sure they are inserted correctly and secured. Also make sure they are not damaged.
This might be a dumb question but do you have the correct tool selected?
CB09U, CB15U? It looks like something you might find when the pen tool is...
Are they offering Flexi 10 or Flexi PhotoPrint 10?
I have dealt with a few of these issues. The ARM sensor is usually the culprit and cheap and easy to replace.
Oracal just recently released a stone guard laminate. ORAGUARD® Series 280 Stone Guard Film. Have not seen any yet so for me the jury is still...
How about Oracals 3951HT. It is meant to go down on low energy plastics or hard to stick surfaces.
Just set one up on our floor for demo and installing one at a customer site early next week. So far it is a kick to watch. It is one fast machine!
If you don't mind me asking, what is your current cutter?
did you run an environmental match before you cut?