Search results

Custom work for someone we don't know? Get them in the door or go to them.. make the hard sell.

http://www.haroldsfonts.com/honeymoon.html http://www.fontbros.com/cgi-bin/commerce.cgi?key=HAFO-HONE&preadd=action

How long of a run are you trying to cut? On my FC7000 I try and keep my runs under 10 feet to keep the chance of skew down.. and make sure you're sequencing your plots to keep the material travel to a minimum. Make sure your grit rollers are clean.. and if it has the adjustable tension rollers...

If it's only one.. think of the time it would take to weed vs overthinking it. That being said, print it on clear and contour cut.. I'd do it on an Edge because it can prime white.. as long as it's not larger than 11.8 on the smallest side..

is the word you're looking for mottled?

give graphtec tech support a ring.. they will usually tell you what's fried.

pull the cover off the pen block.. make sure there is no play between the carriage and track, make sure there is no play in the pen block.. make sure it's all screwed together and not coming undone.. just things to look at.. never had that problem.

Photoshop CS5 and later now have a very similar feature... works good once you get used to it.

What are we crying about in here?

Crikey!

is 60" the biggest latex they have right now?

good tip Insignia.

Pulling pdfs in to illy without the text being outlines will cause it to reset the type.. And if it's a PDF saved from another program, the text will end up being broken up in to individual characters a lot of the times.

you can do anything........... unless you suck at it.

hot.

we are brothers.

check out foalio.com.. it's new but it lets you host a portfolio and people can hire you based on your past work, instead of you bidding on a job..

should have been "helps you pull it out"

vinyl eraser and a repaint?

Everyone does it different. Everyone has different results. Do what works best for you.