I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Atn Mutoh Pros
Getting Ink End when replacing the K cart
I have tried 2 brand new Mutoh brand ink cartridges
I removed the R side cover and inspected the Near End \ Ink End sensor still getting the same error
I suspect the sensor is bad or the Junction board is bad...
Any other ideas?
Thanks!
We had a headstrike, after that the black nozzles begun to drop.
Now I am missing 3/4 of black.
I soaked the head for 2 days. Someone suggested replacing the cap top. We did
but no luck.
I noticed when doing cleanings now I do not get any ink into the waste tank.
Could it be a bad cap? Or...
Monday Morning Folks,
Turn on my Printer on.
No Heater LCD Shows black boxes across, I ran a few prints and the heater it is not working.
Any suggestions ?
Thanks in Advance...
Hey Folks,
I wanted to get some advise here,
I got some misdirected nozzles on the black head. I have done multiple cleanings, manual cleanings and soak the head, and still no luck.
Any other tricks or should I replace the K head ?
Thanks In Advance !
Hello Folks,
I need so suggestions or Ideas on How to make your own application fluid ?
I am in a hurry and I can't wait till Monday if I place an order.
Any suggestions or help would be greatly appreciated.
Best Regards !:peace!:
Hello Folks,
Finally I bought my plotter and software.
I am going to start as a home based part time job.
I need help to figure it out, What sells the most ?
Thanks to all for your valuable help!!
:help:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.