Search results

Good Morning Guru's.. I am trying to find out if there is a way of printing the lawn signs or "bag" signs as they are known around here on my SP540.

Thank you muchly for the order in which to approach the setup, would I insert Unit adjust between Head slant and Y Base or Prior to Head slant. The read out goes to slant then unit, my brain is telling me to adjust the "holder" square first, then set up the slant, otherwise the heads would be...

Hi Particleman My problem is I dont know in which order to do the adjustments, I'd like to put it into automotive terms: "If your car doesnt turn over first check the battery, then check the starter" I think the adjustments are there (somewhere) but in which order are the tasks tackled?

Yes the heads were installled. Unlukily though the service manual is for a similar machine and not all items are the same :banghead:

Does anyone out there in the world of DIY Mimaki JV3 persons have a step by step procedure to completely setup the JV3 75SPII or 130SPII from scratch, I have owners manual and a service manual from a similar printer but at quite at a loss as to any order in which to proceed. Thanks in advance...

Hi There Rippin. I have purchased a used JV3 Installed new heads and was going through just about every thing imaginable to set-up and ajust the Heads and Capping Station (also replaced along with the pumps) I adjusted the capping station as the last thing before I shut down for the night...

FYI All - I had adjusted the capper settings apparently out of parameters before shut down yesterday - oops

Morning World, Just turned my JV3 on this morning after attempting adjustments yesterday and end up with "ERR - Scan" I also noticed instead of just getting the firmware version, I have now a series of numbers below the firmware ID. Once tint the Err I cannot proceed past the screen. Help is...

Head Height. Is there another way besides "Thick & Thin" to adjust the initial height?:thankyou:

:Canada 2: Newbie here:- I have just purchased a used Mimaki JV3, when purchased I was told the heads were shot, I purchased four "Mutoh" heads because I was told they are the same head just with different mounts, They were installed, I have gone through (I think ) most of the setup I can find...