Search results

Its case sensitive try CutContour as the color name had this problem before.

I went through the same thing nobody could speak English then I spoke with Robert he walk me through it and spoke English what a re leaf he will treat you right.

Try Robert at Signage Specialist Inc 303-733-6671 I just replaced my black cyan head it was a piece of cake 699.00 plus shipping robert was real hulpful.

Thanks guys Ill take you up on that offer Dave

I have a Roland SP-300V Its time for a new head Ive been doing some research on line and found pricing any where from 575-950 for the new head I want a Roland head not an aftermarket head from my research it uses a epson DX4 printhead All the heads are epson DX4s one place told me there is one...

Thanks Guys Back To The Drawing Board!!!!!!

Looked Hi And Low Any Suggestions?

can anybody know to get this logo in vector?? thanks Bad dog

Pop In A Cleaning Cartridge

Dave I really don't like being accused of something I didn't do and these are your words: (Only last year(mid 2008?)was another pirate exposed) So I'm a pirate I think you better think twice about who your accusing of what I was just wanting to pass on some software that I purchased from your...

Thanks ken I'll try that:U Rock:

I just did a test print to see how my nozzles were firing and k is fine but c is half k and m is fine but y is orange like it has m in the y I don't even now were to start I'm using triangle bulk ink set up on a sp300v any suggestions would be greatly appreciated Thanks BAD DOG GRAFFIXS

Thanks Kustom I Had To Get In A Couple Months Be And Wrote Down But Cant Find It That Worked Thanks Again

Thanks Kustom I Had To Get In A Couple Months Be And Wrote Down But Cant Find It That Worked Thanks Again

Im Trying To Replace The Capping Stations On My Sp 300v The Instructions They Sent Say Hold Left Right And Down And Turn On The Sub Power When I Do This It Says Service Mode Protected Any Suggestions ?

Well here is my attempt at a homemade take up roll. TURKEYS DONE !!!! DON'T LAUGH IT WORKS!!!!! :flamey:

I built mine from a BBQ rotisary works great. what I did is have it drive a 2" card board tube then throw a couple rubber bands around it slip a 3" tube over that it act like a clutch because the rotisary turns a little fast than the printer prints it works perfect two years ago I got an order...