I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Hi guys,
Just went to do some banner printing and my Cleaning cartridge END message is on the machine. I dont have a spare to swap in.
I really need to print these banners but is it a bad idea to run the print?
I wont be able to order a replacement till Monday so won't have it till...
ah!........now thinking about it it did have jam recently when it started cutting a bit too close to the end of the vinyl and it got caught up.
How did you reset the strike sensor?
Thanks guys,
I did wonder if it was something simple as surely a more serious error would show up when you power it on and you get the error flashes.
Where would i be looking to get at various sensors etc (i'm guessing opening up the case fully) something i havent done but ive built a fair...
Hi guys,
Hope someone can help.
My HS15 cutter has just stopped working. It powers up fine and does the correct bleeps/flashes but the carriage doesn't slide to the far end like it used to to complete the boot up sequence. No response from the buttons either.
Can anyone help, i REALLY need...
ok now im confused a rectangle with curved corners with and inline applied so its a hollow frame just worked 100% Blade lifted and cut the inner line no problem.
But send something a little more complex and it just stops????
Cut the letter R works fine, type the word ROB and cut that and...
Hi, slight problem we have been unable to get into diagnostic mode, no matter how many times i have held reset then powered up it wont do the alternating lights that show its in Diag mode, sorry forgot to say this.
Unless i'm doing something totally wrong?
Ok it does perfect circles that weed spot on.
So i just tried a test, i cut a circle all was good, i then made a shape in flexi from a big circle with a smaller circle cut out so it was a continuous shape. It cut that spot on as well!
So next i did the same shape but cut a circular hole...
Its not the Plus just the standard HS 15 without swivel knife. I have the driver set to HS 15, there is a plus Driver as well.
Thanks again, really stressing as got a job waiting to go grrr
Yep all the same as yours, i tried playing with parity and Flow just to see if anything changed but that are back to same as above now.
not getting any error lights/beeps. The blade just stops and the Run single light stays on.
Hi, ok they are
Res 196.850
passes 1
Advance a plot Ticked
Send arc faint (not used?)
Knife offset not ticked
Packet size not ticked
Curve quality High
Hi everyone, just signed up.
Ive just got hold of an Edge2 and a Hs15 cutter to go with it. I run them both from Flexi.
Edge seems fine but the cutter works fine on everything except when it cuts curves.
If i send a square box to it it will cut fine, star shape fine again, if i...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.