Search results

any ideas? I have replaced the carriage and maintenance station with no luck. The lines appear in any print a few minutes after starting the first print. After the machine is warmed up the lines appear much sooner. The lines are printing bi directionally while the printer is in uni-...

I replaced the cursor carriage and when I tried to pull ink through the heads I noticed the print heads are not sealing against the maint station. I tried removing the carriage and double checked my work. I also replaced the maint station this morning on the advice of a service tech. Same...

Alignments on Falcon There was a noise that became worse as it printed. You could actually feel a slight bump as the carriage went back and forth. I thought it might be a bad bearing but the bearings are not available individually. I had to buy the complete assembly. Can anyone out there lend...

Alignments on Falcon Thanks for the reply, Any idea where I could find more information on alignment? Thanks, Robert

Mutoh Carriage Problem Since I did not replace the print heads, just remove and replace them am I good to go? Any help would be appreciated. Thanks, Robert

I have ordered a new carriage assembly. Has anyone replaced one before? Any tips? Thanks, Robert

I tried lowering the heat ( off ) and the print head is in the high position. the noise is still there. The marks are also still there. Something is making the carriage run unevenly. Any ideas? Thanks, Robert

A few inches into a print these lines appear. When the lines start to appear I can hear a bumping noise. As lines get worse so does the noise. I can put my finger on the print head and feel the bump. The printer is printing well except for these lines. The nozzle checks are fine. I have...