I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Really with AliExpress for me, it’s buy it and try it. I’d try it for $28. I use a slightly cheaper aluminum one from Amazon for my perf cut blade and haven’t had any problems with it.
I rarely have any issues with Cutting Master, but sometimes I'll toggle between cut by layer and cut by color to see if my lines will show up. Actually, I usually look here when I have a problem with TOO many cut lines to see if I can find the issue.
Did you draw it from scratch or use a graphic that was already made? I'm trying to figure out if you're starting with all the paths you need and then losing them, or if you're missing some paths to start with.
Sent from my moto g stylus using Tapatalk
Thank you for the help everyone. It took me some thought to finally realize that scale units on the holder were the same as the scale units on the loupe.
Yes, remaking a corrupt profile on a printer with a built in spectrophotometer isn't bad at all. You can get all the specs for passes, optimizer, etc from the media locator, and then do a color check without wasting much material.
Sent from my moto g stylus using Tapatalk
I bought a couple of the aluminum ones recently for testing. One thing I'll note so far is they are about twice the mass. The Graphtec is 8g. The generic one is 16g.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.