I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
great.
now need to know which is which
do you still need to pre-mix air with a cylinder/butane ?
is it something to do with mains gas pressure, ? with a cylinder you can adjust the pressure with a regulator?
I want a ribbon burner and a cross - fire plus a hand held burner
but I need it to run from a butane cylinder.
I gather they are available for natural gas/air mix
is there a difference
if so what
hello - good news I fitted a black chip card and it works
I fixed the snapped pins on my cap station and it works
THEN
NO media
from the vj status monitor
media is loaded
the only thing I have done is fill the cap with solvent
I printed a test print with no ink coming out twice
one of the black...
there you go, you may have similar problems , the ramp still needs to be working the spring acts against the carriage after it ramps up
any one have the parts before I attempt to drill and tap some 2mm stainless button heads 6mm long and fit them from the inside out
I havn't ever fitted
dx5 decoder
I live in the London
I just 'used to' buy a 7880 unclip the head, cut the lines and drop the rest of at the recycling centre on the way home.
hello, I used to get the fat big strips just like you have pictured, its not the cables
it you are connected to the internet while printing and that is what happens
the over temp error was simply there was no ink in the head at all, until you pulled all the air out of both the head and dampers...
the r with 4 digits following model of that huge printer firm is basically a 17 inch wide printer so they need to not equip the head with squirty power after that, so they put a bit of elecrickery magic on the head under the potting shmoo to make the head do exactly what it is doing in yours...
I am still having agro with the driver in onyx, says no .dll
I had rip centre for mutoh on the pc - version 11.0
then I installed 11.1rip-q for 628
I am not too concerned at the moment as I need to get the printer going
do I need to remove everything and start again.
I don't need the...
you need a decoder card, what you failed to do was write down the model number of your head, as there are two types of unlock cards
depending on what serial number
hello its onyx 11.1
I have installed the valuejet status monitor
have 2 errors
1. no media loaded
2 . one black cartridge needs changing
would it fail to initialise if there is an empty cart in it?
I have now removed the capping station and the wiper
it still happens
the parts also feature on...
when doing cr carriage move for maintenance it goes over
I think its the paper sensor
or is it encoder strip or encoder densor
its really clean the strip machine like new
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.