I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
au off
To disable Windows Update in the other Windows 10 editions, you have to set NoAutoUpdate to 1 in HKEY_LOCAL_MACHINE\SOFTWARE\Policies\Microsoft\Windows\WindowsUpdate\AU. If the corresponding keys don’t exist, you have to create them.
before you replace it
check the head cable and the fuse on mainboard. There is a service manual with a step by step guide how to flash empty mainboard.
no errors at all
no error code it is just warming up very long and hanging on warming up i check the firmware version tommorow but i think it is the latest which could be used with bulk inks. thanks frimware 1.03 i think
Big thank you for all who has helped, i have a problem the printer is printig terrible its a vj-1304 and im using ergosoft my problem is this see picture
if i turn the heater on in rip it is just warming up but not printing
go to maintance menu and first point if i remember and check the heaters if not working open it and mess with a volt meter, if fails change the part if good maybe relay. Google how to mess heater
Please help where can i find on the printer something to turn down the PLA2 becouse it goes to hot over 50 i have tried platen adjustment but cant set to 30 it says end warm up and continues heating, thank you my firmware is 1.3 runing bulk ink.
The heater is on after i turn the machine off...
this is from the 1204 manual
4.7.3 Replacing Cleaner Head (Cleaning Wiper)
NOTE
Before replacing the cleaner head, remove the following covers.
• R side cover: "4.2.1 Removing R Side Cover" p.4-7
1. Remove the cleaner head from the cleaner head by using tweezers, and lift it from the holder...
sorted
if you get this error get a volt meter set to ohm and test the heating elements if is showing numbers elemnt is good if not is down. Test the termistor as well but go to a radiator or close to something what is heating be carfull not more as cca 40 celsius and if is ok the numbers...
another soulition
there is a easy card and easy hub is interesting becouse on the photos it look like it can be a diy job for me simple pcb and basic chip. Can you please name the software or upload it somwhere and som details what are readable on the reader and card. If i can make it diy i do...
check t-fence
check t-fence for dirt crack wet and the sensor which is running on it. plug out the power cabel from the wall and the printer as well wait 5- 10 mins if not enaf wait a little bit more it comes back 99%.
same problem
I just swap my maintance station and the printer is freezing and if i restart it goes to this coma anybody knows something about it please help
i found it
it was in the self diagnosis menu thank you i have reseted the flag one more question the pump is sucking the ink or cleaning fluid very slowly thru the pipes wich are clean is it the head or the pump wrong or boot???
Thanks
how can i cancel the washing
Pleas can someone help me how to cancel the washing, if i turn on the machine it want cleaning but just hanging on during washing how di i cancel it
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.