Search results

scan motor errors try and clean bearing assembly and bearing rail,, if a lot of resistance on print carriage especially when not connected to the motor( it should run free) if it is not it could be the linear bearings!!!! cheap to buy at a reputable bearing manufacturer than roland because...

scan motor errors Hi, try disconnecting the print carriage from the cut carriage and then by hand move print carriage side to side and see if there is any resistance,, they shouldnt be because now it is not attached to anything ,,ie, the scan motor,, then try and move the cut carriage which...

grinding trust me its the bearings,, oiling too much might quiten them down short term but will also wash out the special grease inside the bearings and damage the felt pad on the end caps put on by the factory bearing makers thk,, its called linear technology ,,phone and ask them! back and...

sp300 Hi i have the same machine and i can say 100% its the carriage bearings,, roland want around 1200£ to replace thes as they come as a unit,,,3 carriages plus the rail aswell,,, i only needed 2 so i went where roland buy them from, just go on the net and look for thk bearings in your area...

sp 300 pinch rollers Hi, the only problem i have had with the rollers on the same machine is that the rubber tyres have come loose and this causes all sorts of problems,, take a close look and see how they are performing,, you can buy yhe wheels seperate cheap and anyway unlike the newer models...

sp300 bearings found a company in scotland distributing for thk,, very helpful sending me two bearings out staight away,, should be up and running shortly,, let you know:thankyou:

sp300 bearings thank you for a quick reply mate,, i was thinking about that,, will let you know if i get sorted:thankyou:

Hi everyone i was wondering if there is a second hand sp300 out there for spare parts,, i need the bearing assembly units behind the cutting and print carriages because they have collapsed!!!! Roland will only sell the carriages with the rail complete at a cost of 900 euros,, i can get away with...

hi i have a roland sp 300 showing the sp??? and now telling me i have a unrecoverable limit sensor ,, what is my next move? do i replace sensor or sensor and strip just in case? help

hi, i have a problem on my sp300 it comes up with sp ??? instead of the usual sp 300 and then service call 1010 then unrecoverable limit sensor,,, how do i go about changing these please,, service mode wont let me get passed this message