I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
We've been using it for several years, did 2 walls last week one was 37ft x12ft and the other was 45' x 12ft, it's great to work with. Tried Oracal wall once but it is thinner and more difficult to work with. Expect to get a release to start printing for a 71'x12' tomorrow, that will take 2 of...
For the past 10 years we used a verity of 13 oz scrim materials with out a problem. About a year ago we switched to Grimco's Forward, made 20 retractors for one customer for a trade show using the Forward material which had a solid dark background, half of them curled so bad the customer...
Assuming your print is the full 4x8, we cut one of the 4ft edges of the print, aline it on the edge of the substrate an apply a strip of masking tape across the edge of the print with about a 1/4" of the tape on the print, fold the rest of tape down the edge of the substrate and onto the back...
Harbor Sales carries the material. Alumalite is 2 sheets of aluminum on coroplast type material rather than a solid plastic, end caps would give a cleaner appearance. Not sure if water getting into the corrugation and freezing could cause a problem.
ConraVsion makes a material call back light which works like normal perforated material during the day, but it has a transparent adhesive so it allow light from the inside to pass thru so the graphic to look like back lite film at night so the image shows at night on the outside. The material...
We don't have a router, usually mount on 3/16" foamboard or ultraboard an cut with a knife, put easel on back. Last year we had order for 6 double faced with a small base stand. We had Harbor Sales route 1/2" Ultraboard, we over sized the prints about 1/4", wet mounted the prints on the precut...
I have not tried AlumiGraphics but have tried another textured material that does not require lamination. It was installed indoor in a mall and after 2-3 months we had to replace with another material because the image had worn really bad. I assume foot traffic and floor scrubber took the ink...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.