Search results

You need a printhead calibration that cand only be done in the service menu. Ragnabrok has described it very good. The yellow shadow will be resolved after the bias and horizontal calibration. If you don't know how better call a tech.

You can hold the cleaning stick by the end and move the carriage a little bit to the right to reach the first printhead.

If it's not the heating or vacuum then it could be the pinch rollers.

Hi. Clean the pins of the "big flat flex cables from head board to carriage board" with isopropyl alcohol. Inspect the pins from that flat cable to see if any of them are loose. Check the humidity of the printing room. Instal a UPS!

Are you cleaning them in the left side of the printer? You should have enough space.

It looks like the printheads were mechanically damaged. Inspect them (look at the nozzle plate for schraces in the back of the p-heads) at the cleaning station in the left side of the machine. If the printheads have schraces in the back part of the nozzle plate, then the problem will be solved...

Mechanical Issue 1. There is a bad contact/cut-line in the cable. 2. Drive wire attachment screw on cutter carriage is loose. 3. Low wire tension. 4. High scan motor hours. How many hours does it have? At 1500 hours you have to change it. 5. Bad or burned IC's on servo board Action 1. Check...

0010 Scan Motor Deviation Error 0040 Scan Motor Overcurrent Error 1 (Big load is put on the motor movement instantaneously.) It's not related to the encoder stripe it's a mecanical or electrical problem related to the scan motor.

Hi. Looks like an electric command issue. Check or replace the print-head cable. Clean it with isopropylic alcohol. If you don't know what you are doing wait for the tech.

Could be the material. Try whit a diffrent material.

In my opinion perf cut should be used when you make a sticker sample, not for production. Before cutting a material, especially when you use perf cut, make a test cut. The perf cut should cut 90% of the suport paper, not 100% :thumb: It's advice to have a cutting strip neer by. :rolleyes: Have a...

If you think this is from the material, then try another one :peace!:. Prefeed both of them to make sure it's not the problem of roll weight.

Solving Roland 0001 ERROR OK. This is a tricky error. I managed to fix a Roland XC-540 that had this problem. My english is not so good, so excuse my future bad spelling. So the 0001 Error Code is explained like a "Feed Motor Deviation Error" Indicates a communication error between the...

It's not from alignment. The cleaning will not help. 1. Try to print on another material. Mabe the coating of the material is not so great. 2. The material or the printer is loaded with static electricity. Verify if the printer is grounded. Clean the media whit technical alcohol or medicinal...