Search results

Got a odd problem, when trying to add the old gal (SP300V) to onyx it crashes while trying to install the drivers, even tried a fresh install on another system and same issue, can add the mimiak and mutoh printers fine. Anyone encountered this before?

Roland SP300V, I'm more use to profiling Mimakis with flexi or efi XF so versaworks seems a bit alien to me.

Anyone any ideas?

Found an annoyance with versa, when I select to create a new media profile at 1440x1440, I only get the option for angled screen halftones (which prints nasty), is there anyway to make it so I can use dither or any other halftone?

Fresh from a versaworks issue, and now in to a flexi 10.5 profiling issue, once I get to the multi-ink limit page change the percentage to the desired percent based on second print verification and then clicking next button, just does nothing where I’m sure it should go to the next step of...

yup did the trick, thanks

has anyone managed to get a i1pro 2 working with versa 5.51? when I go to calibration if throws up the error 4087 and if I click mesure it throws up 4085/7 any advice would be most welcome as I was under the impression the i1 was backwards compatible (printer is sp300v) Thanks

problem, I now have is if, I went new head route and the bloody lines are still there, will have to think about it over next couple of days.

FFS now get head heat error, think i'm gonna give up on the old bird.

Changed over the head cables and now I get the following problems shown in the photos, one is of the test print that looks horrendous and the other is a photo i've been trying to print since this whole mess started. Will be bald by the end of the week at this rate.

Nope, printhead has been in for years, as printed many things above 25" before.

its bloody annoying as it only happens on prints wider than 25 inches.

this is a close up of the patten its printing every 3-5 inches after 25" prints, which is strange as it prints perfect for stuff below 25 inches

this seems to happen on prints above 24 inch only, this is a valuejet 1304

Just started to print a photo to canvas and I get these strange ruler type marks being printed, see photo below; I can't for the life of me understand why. Using fiery xf 7.1.1 but nothing has changed in the rip

All sorted now

thanks just sorted now the damn thing aint pulling ink via the fullup

Hi Guys, just a quick question does the flushbox tubing sit in the two holes in the plastic box or do you put them straight into the tubing for the waste bottle?

Just checked and platen and pre don't heat up, but everything is dry to the touch, guess i'm going to need to get the crimps out and have a go a reconnecting. My only thought is why would it be live that in the first place.