I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Hello,
I’m looking for UV printer 320 cm wide (printing zone) with roll to roll system.
The most important things are:
High speed printing
Very good quality, no lower then 600 dpi
Possibility to printing double sided
Mesh kit option
Easy maintenance
Please, can anyone recommend me some...
When you turn on the machine you need hold left and right buttons together to reach parameter menu. Look for parameter ''41 model'' and try change to other number.
Siemano
Zakup tej maszyny będzie najgorszą decyzją w twoim życiu. Mamy u siebie jedną i jak mam przy niej coś robić to mnie kur..ca bierze :P
Maszyna jest mega problematyczna i awaryjna (taki nieudany eksperyment mimaki). Zdarza się że drukuje dobrze przez pół roku :) ale jak się zacznie sypać...
In service manual:
ERROR 49 CUTTER SOLENOID
An error occurred in cutter
control.
Turn the power OFF and turn the
power ON after elapse of 2~3 minutes.
In a case of recurrence, contact your
local distributer to call for service.
1. Check that up/down operation of the cutter
is smooth.
first try cleaning the encoder (use alcohol :bushmill:) and encoder sensor (with air ) or replace them if they are in bad state, chack also head data cable.
perform calibrations once again.
In the worst case it can be slider board or mainboard :(
How should the fine-adjustment look like? Like my third attachment - or should there a space between the lines (att3)?
You have to choose the place where the lines overlap perfectly, tommorow i will post here pics from my adjustments.
Try cleaning the encoder, it can cause your problems. If it did not help check your head slan adjust ,you can find it in your service manual but you need microscope for this.
If you change head angle after slan adjust you must perform all drop position calibration again.
Remember that at the end...
You have to do head drop position calibration.
Go to service mode , after switching machine "on" hold down together Function and remote button.
Go to "function" find "adjust" and select "Drop.pos adjust".
You have to make all Drop pos. calibration (there is BIdirectional calibration too).
It's...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.