Search results

Hello everybody, I need help for wiring a Kala bunny 1400 laminator that was deconnected on the switch if Someone have a picture or wiring diagram i will apreciate thanks for your help

Re-adjusting the voltage immediately at 2.7 to 3 - 10 minutes later at 1.8V On the service Manual the adjustement seems to be done quickly... Im folowing your advice i waited 10 minutes then adjust to 2.7 after 10 minutes (immediately 3.5v) i hope it works

Hello guys, i m having the same issue with the 4th crop mark detection i swabed the sensor but still nothing after about 20 try.. The issue is on both 3 sheets laminated..

Ready to print

Is there an end to this issue

No Ideas? No Ideas???

graininess I have the exact same problem as on this thread http://www.signs101.com/forums/showthread.php?112052-CJV30-60-bad-printing-after-new-DX5-head-installed&highlight=cjv30+slant+adjust i'm trying a slant adjust but wow... If someone can help me thanks

Grain As i told i successfully combine print and cut by deactivating y detection mark repers and i get around this issue for the moment so as to catch up the production delay. BUT i have some grain picture as show on attachment .(upload won't work) All is new on the machine and i have...

I still wait for a mimaki local tech call back (since monday).. So i dowgrade to 2.2 Firmware but sill have the issue. maintenance manual say: ∗∗∗∗ ERROR 250 ∗∗∗∗ Y COORDINATES An error was detected during scanning operation. Turn off the main power, and turn it on a little later. If...

Ok good i 'd better screw the other side in this case. i now have a very noisy cutter when i touch it the noise stop... I tried a print and cut combination but i have a 250y coordinates blocking error.. What should i do ? Is it the tension of the belt or the motor axes ??

Yes thats it - but media clamps are optionals they are only recommended for thick medias. (i only use one on left side i have a brand new for right side but screws are very small and i dont have some) In fact that was due to the head plate when i replaced it i put it twisted.. Thanks vander

Lines scratch So were back on business :) With a pretty good quality but with lines scratch (cf pics) The media is well armed with a good tension without irregularity of position. Any idea ?

Thanks as suggest by sightline it was that :))

Thx sightline Yeah great the new Board is mount with the old parameters the test print is perfect!! I now only need the 2.20 firmware and do à slant adjust and its all ok!! Thank you for your help:))

To acces the mode i press remote at boot ..(is it correct?) maybe the prm i use is not the good one... i can't even upload and dowload from the new board.

when i upload the following message appear: "cannot receive the data check the status of the printer" and the printer still on" E74 TRANS DATA "

I replace the old one and boot -+ im now on f/w updating * transmit start* mode can you give me the way to do the backup : firmware utility to use (i have FW Update tool III V2.3) and i have a cjv30-TPC prm file ... should i upload dowload etc... By step thanks

Hi sightline thanks for your quick answer Ok it now boot as a cjv30-100 - but stuck with choose an ink type ss21 etc... when i press ok it re-ask choose an ink type... How can i back up data from a burnt motherboard,? If i only plug the power cables to the farmer board should i be a ble...