Search results

can i and should i switch out my inks to ecosol max 2 im surrently running ecosol max. is it possible to run the max 2 cartridges on the sp300v?

so recently moved the printer and it started showing 0.0" when setup. it would sometimes go away if i moved the pinch rollers, but now if i move them i get pinch roll errors. tried turning off automatic end detection and nothing, tried letting the machine sit unplugged for a few hours and...

im using CMYK in both versaworks, photoshop and illustrator. im exporting psd from photoshop to illustrator (colors stay fine), then im adding the cutcontour line in illustrator and saving it as an eps, i have also tried pdf and the same thing is happening. test print is correct im missing a few...

so i started printing my car after new heads were installed and everything had a cyan tone, (fixed it by adjusting curves) now im printing other things and the colors are completely wrong... attached are what it looks like in photoshop and illustrator and what i get from the printer... two very...

so i have tried every solution from changing parts to replacing heads, i think this is it for my printer

never did figure it out, if anyone knows someone near lebanon oregon that could help it would be greatly appreciated

i replaced it once, had the issue of a short when we moved the machine to our last location. and if the transistor was the issue it woulnt fire the other head when the cables are swapped. on the carriage, im going to try ordering new cap tops and see if that works, but they are both full of ink...

im convinced its a page file, have verified the head works on another sp300I but its not firing on my sp300V. anyone have a sp300v and want to drop the page file binaries

yes we went with the same rating and wattage but with glass fuses to tell if they are blown, im a drafting and design person so i have a replacement board being prototyped since this thing seems fairly common on this model of printer

3 different print heads and the same issue, they cant all be bad, fuse is good, and as stated swapping the cables going to MY and CK MY prints either way, in is flowing, can see it being pulled through the cap top tubes and verified with a syringe. imm really at a loss as to what the issue could be.

did the glass fuse upgrade same fuses easier to replace

oh i need this fixed my car wrap is due for some updates.

the ribbon cables from the head are clean and brand new

where is the transistor located? im wondering if that could be the cause, i have one more head from the machine that i can try tomorrow ill put that in and see if it works

thats all been done already and thats where i am now. when swappping the heads i swapped the cables same issue on two different heads, no printing on ck head despite being plugged into my ports my still prints when plugged into kc ports, swapped to original print head that was replaced due to...

Roland SP 300v listed are the following steps ive taken so far: replaced the heads replaced the captops replaced the fuses on the main board (this was the issue last time this happened and replaced with sockets to avoid this issue in the future) swapped the head wires on the carriage (magenta...

and after flushing the head it looks like i may have a bad head, fuses are fine but not firing either color again.

its progress, now that ive confirmed ink flowing i have two options. do a drain and fill, with cleaning solution to further recover the head, or the one im currently doing which is printing a 6" long 28" wide strip of 100% bk and then a 6" x 28" 100%cy block

got smudges could be a bad/clogged head. guess its time to order a new one

took cap top off and used a syringe to push and pull cleaning solution through the print head, ill know in a little bit running a fill cycle right now, is it possible one of the two fuses on the print head itself went? how would i test this.