Search results

Just recently I had the y motor go out on a graphtec 7000 signwarehouse version VInyl Express machine. I had an another y motor left over from another graphtec fc7000 so I replaced it and got the machine up and running again. I did a factory reset prior to replacing the motor to see if that...

Hi everyone. I have a quick question, Is laser cut tactile lettering for ADA signs considered compliant. I thought I read that the edge has to be broken?? Any info is appreciated. Thanks,

I am having a couple of issue with my mutoh vj1604 and was hoping to get some insight. The first issue is I am getting ink backing up(channel contamination into the lines) equivalent to what would happen if you did a head soak for along time. It typically happends when the printer sets over...

I have an fc7000 that has started giving me a recurring problem. When doing a (f1 key) Rear set to initialize the material, the x motor frantically spins and cause an x position error. It will not work for awhile and then it will start working again. I called graphtec and they said it's the...

Hi there. I have a mutoh 1204 and 1604 that run both the same flexi profiles and same material. The solid black (k=100) on the 1604 seems to have a slight red hue to it as compared to the 1204. I just put a new printhead in the 1604 out of an Epson r1900 printer. The nozzle check is nearly...

I was curious to find what other peoples experiences were with aftermarket wipers. I have seen the blue ones online and understand they may be a bit taller and stiffer. Do these were just as well at the Mutoh wipers??

I get the e071 err pf current error on occasion. I haven't actually physically printed with the machine yet as I am rehabbing it, but I get the error when I am pressing he forward button from the control panel. It will feed properly for a little bit and then jump probably a 1/2 inch or so then...

So I picked up an older 1604. The maintenance station was caked with old ink all over the place (i.e wiper, gears, etc.). I removed the maintenance station and cleaned every little nook and cranny, hoses, took apart pump, etc. to get it working again. I dropped it in the machine today and...

Curious to find out if anyone has used a printhead out of a r1900 or r2880 to replace a printhead in the vj1204 or similar printer?? I understand you would have to change the manifold to the solvent manifold, but was curious about other peoples experiences. Are there other Epson printers that...

Hi everyone. I have a vj 1204 and recently noticed that when printing solid black, I was getting very poor quality(almost starts off green and then gets a little better). I did a nozzle check and noticed that approx half of the black pattern is missing. I did some research and did a few head...