I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
That was close, but not quite it. The e isn't connected so that's what I see that is different. I was able to figure it out though, it's Dessau Bold Thanks though!
Roland XC-540
This is just a basic intermediate vinyl from grimco
This is a test print from the versaworks software
Ink is 20/20 ink from grimco
The test print is pictured above which has a heavy presence of magenta
Hey everyone,
I have a quick question and would appreciate any help you can provide.
I got this printer used from my father in law. I ran a test print and the result is in the photo below. I have sorted out a profile that works around this issue mostly, but I would love to just fix it. Anyone...
Well it is with much relief and a dash of embarrassment, I write this to tell you the problem has been solved. I logged on this morning to read your reply and with a bit of desperation I walked to the printer seeking a last ditch effort. After considering the cable in the main board was oriented...
So at this point, I have replaced, the carriage cable, the sensor and the board and I am still getting the right pinch roller error. I am at a loss. Is there something that I am missing?
Thanks for the help. I tried putting something in front of it and sliding it in front of the pinch rollers and it never gave me the star. So I am assuming that means it's not working. Just to be sure, you are talking about the sensor in the circle on the attached right?
I did a sensor check and I got this. I looked it up and it says the media sensor wasn't on, but I didn't know if that meant it wasn't in use or it was broken. Did I read it right from what you know?
Yeah I disconnected those to pull the board out to swap the cable. I'm guessing there is no way to narrow it down a bit more so I don't end up buying more parts that don't need replacing is there? One thing I noticed is that the brief pause the carriage makes when it encounters the pinch rollers...
Hey Guys,
So I have a Roland XC-540 second hand. A couple of weeks back started getting the issue where I would get pinch roller errors when I would setup new media. And occasionally getting the 0.0 width thing as well. I didn't think much about it, did a breif googling and didn't find much...
Yeah I would say that when I get the "Out of Ink" there is about 1/5 of the ink left. However, after the comment about shimming the cart up, i noticed my machine isn't level with a lean that tilts ink away from the machine. So I leveled the machine out, but I still have the low ink warning. I...
My roland xc-540 is saying that I am out of LC but the cartridge has quite a bit left. I don't want to drop a couple hundred on new ink when there is plenty. Is there anything I can do to reset the chip or anything? I would rather watch the printer for the ink to drop out rather than waste all...
Yeah we also do laser printing so I am using the term calibration because that's how it's referenced on the laser printer we have and what we have the es-1000 from. Our roland is printing a magenta cast in light grays and light shades of other colors even pure white. So I need something needs to...
We have a Roland XC-540. I have replaced the existing heads in an attempt to save them. But it's to the point where we need to replace them and I am going to replace them myself. The question is, I need to calibrate the machine, but I don't have any of the equipment versaworks lists for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.