Search results

You need to do the daily, weekly, monthly maintence and don't waste your time trying to print if you are not controlling the humidity and temperature of the area you are printing in. Run a nozzle check pattern before you start to run jobs and clean the heads as needed.

Arnold SafeMag is made by Flex-Mag

Banner hemming tape with drilled and recessed holes and top off with a drop of silicone that you smooth out so you don't catch the hole with your blade.

You need to know what is behind the stuco... I would use dibond as the sign face over foam and mount with french cleat and anchor accordingly with proper mounting hardware, use silicone in holes to hold sign in place.

I'm pretty sure that it is just a silver ink cartridge that is only availble in 220 cartridges and that other metallic colors are formed when you print the silver with other colors overlayed onto the silver so it gives you the look of gold, bronze, copper etc. Kind of the way you can print...

OK, I know this printer VERY well, and ONYX I can fumble thru. I wouldn't worry about turning off your lc lm. Double check your inkset that you have in the printer. 98% of people run this printer CMYK and do not even have LC or LM loaded. If you are in the 2%that need earth and flesh tones...

White cor-x with 01 Red cut vinyl in Helvetica for a lawn care company. I can't believe that I was so proud of such a simple sign 16 years ago... I actually did run across the picture of me smiling with the customer picking it up, it was simplier back then for sure... man, you can lose a...

metal laminate Go to Ace hardware or your local hardware supplier and they will have metal laminates to choose from that most of the time have to get ordered in, but never took too long. I liked Wilsonart the best. A few things you should know: 1. If doing exterior work ORDER WITHOUT...

Start with the cap top. If you run a nozzle check pattern is there anything on the black and blue? Could be a loose cable as well, but most likely you are not getting a good seal to pull ink through the printhead on the capping station... Here is the list of what to go thru and I hope that...

I used this software in the past and remember paying alot more then $150 for it. It is a bit complicated so you would want to see if it comes with a support contract or how much support is going to cost you. I know that a lot of the issues where caused by our network being one of the first...

I have run cor-x, sintra, banner, vinyls, MDO, and acrylic. It can struggle with MDO that is not flat. Gerber has updated the firmware and have a 2pass mode that looks pretty good. I know that if properly installed you will not have to change the bulbs on a Solara UV2 three times in a year...