• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. Graphtec CE5000-60 Defaults

    You should be able to rotate the image on cutting master. What media are you cutting. I am interested in cutting some stencils.
  2. Using Epson 1400 for Decals

    I have a 1400 with cobra cis pigment inks. Is there a media that I can print on to create waterproof decals? I may be laminating and contour cutting using my graphtec cutter. Will this pigment ink also stick on printable heat transfer vinyl?
  3. Graphtec c5000-60 help

    that is all it shows, i have been running this cutter for 3 years with no problems. i do get a novram init when i power up but it will not go beyond "no media"
  4. Graphtec c5000-60 help

    Really? Thanks you sure helped me out.
  5. Graphtec c5000-60 help

    My cutter is stuck on load media. Any help is appreciated.
  6. Problem with cut master/illustrator

    I just set up my cutter last night. I had an issue cutting from illustrator using Cut Master. It seems that when it is cutting it doesnt cut the complete image. I think I may have the settings wrong or the vinyl size wrong somewhere in the page setup. It will act as if the roll is smaller...
  7. My first project

    First of all I thank you all for your input. Sign solutions, when did i ignore anyones advice? The reason that i thought about magnetic is because its my only transportation to my regular job. when i do letter it i will definitly be sure that it is legible. I might just go ahead and letter...
  8. My first project

    of course you cant read them, its a low res jpg. and only 1 inch in size. lol.
  9. My first project

    its not abandoned, i will be using it for other projects.
  10. My first project

    One of my first projects is to put some signs on my truck. Most will be magnetic. I need some input.
  11. Almost ready to get into this mess

    Looks good, I will take it!!
  12. Almost ready to get into this mess

    Ok so i finally got my 24" graphtec cutter. I have been screenprinting textiles for about 10 years, and now I will be setting up the vinyl "department" in my garage within the next couple weeks. I am totally new to vinyl. I have absolutley no idea how i should be pricing this stuff. Should I...
  13. tools for the trade

    What other tools besides your vinyl application supplies do you carry to an install sight? I will be doing just vinyl but i dont know if my Dewalt 18v set will be all I need. What about ladders?
  14. Gx-300 Vs Cx-300

    Thanks. I will only be using it as a cutter. I will be going with the CX then.
  15. Gx-300 Vs Cx-300

    What are the differences??
  16. Need advice

    This is my very first post. I have not even visited the introduction thread. I am a screenprinter and want to get into vinyl graphics. I have never done this before and plan on buying sign equipment by the end of the year. I am looking at the Roland GX-300 from signwarehouse.com. I would...
Top