Search results

Hello, When head heat message appears at the start up of the printer it could be the head cables, maybe you haven't inserted them well, you need to check them again if you haven't replaced them i highly recommend you do it. Because even if the fuses on the motherboard are blown, no message...

Hello; First Try to change your print profile on this media, and check if you have the same problem with other medias.

Hello Jeff, Listen, go and check all your ink id boards, and then put back the ones that you know for sure that they are good, and leave the other empty, turn up your machine, and plug the cartridges into there slots with a new chip cards if you have new ones, after that check if the chip cards...

Hello, Here is the manual of sp300 roland. https://www.manualslib.com/manual/1077504/Roland-Sp-300.html

Hello, There is i rubber bung on the ink adapter that need to be replaced from time to time, and you have to put every thing back together as it use to be, once it's replaced. And since the rubber are new you have to push the ink adapter little harder so that the needle could perforate the...

Hello, Check your black head cables, and if it's possible change them.

It seems that some thing is shorted may be the broken pin on the cyan ink board is touching other pins, because even if there is a missing pins on one ink board id, the printer can get info from the other cards. Try to change the ink board id first before changing the junction board.

Hello, This kind of problem could be caused by, Not an original ink Bad media Bad profile Some clogged nozzles Poor head printing (if your head has reached the limit). Make sure that your profiles are well installed on your Flexi software,and try to use (fine and fog) interweaving effects...

Hello Digiprint has the best prices for original Mutoh spare parts. https://www.digiprint-supplies.com/en/vj-1604-print-head-assy-df-49684-pphmuvj1204 Good luck.

Hello, If you get CMYK read Error, it is probably one of your ink cards which is causing this issue, you need to unplug all cartridges and plug them back one by one and check on (ink status menu) if the ink cards is being recognized each time you insert a cartridge into its slot. Good luck.

Hello, I have a Kimoto Freecut ec2000 plotter that displays this message (data 102) during initialization, I unplugged all cables from the motherboard and cleaned the dust, but the same problem occurred again when I put everything back in place. Now i am stuck on this error message, i did some...

Hello, The life time message that you got is totally normal, if you reach the number of motor cycle limit of the pump this message appears, which means that the maintenance station need to be changed, and it is probably clogged and that explain why you don't see any ink on the waste tubes when...

Hi, Actually i have a copy of flexistarter 10.5, just give me some time to upload it for you.

hello, From the photos that you had posted, it seems that you have probleme with the third head, check the tubes of the third head and make sure that there is no air inside and the tubes are full of ink.

Hello, you need to check the fuses again and you have to solder the triac on both sides on the Head Driver Board, if the probleme persist you may have to try a new Head Driver Board. Goodluck.