Search results

solaris but ive never had any problems with them until now

during this process its having me remove and install the cartridges. now its saying have "wrong cartridge"

ok.. thanks crny1. i appreciate the fast response times from ya.

ok.. i selected cymkcm. is that the correct selection? hopefully after its done "filling ink" i can get back to a good test print and production.

I shut it off and disconnected it for five minutes and now it is "filling" is it going to waste my entire ink cartridge? I read on another thread that when someone selected pump up it wasted their entire cartridge

theres no error code. it has me select the color configuration lc lm or cymkcm and then states cancellated for motor or something. its 84 degrees in our shop.

ive got the service manual but not sure where to look or what to look for to fix this issue.

ive got ink flowing into both dampers now. however I selected "pump up" in the ink menu and now its asking for my ink type and when I select either ink type it states canceled to motor protection. now what? haha feel like ive fixed one problem and cause another

I believe Ive fixed the problem however before that I selected "pump up" in the ink menu and now its asking for my ink type and when I select either ink type it states canceled to motor protection. now what? haha feel like ive fixed one problem and cause another

Just to verify Im not screwing anything up. Im trying to pull the ink from the damper? I have been doing that and it is a good seal. The syringe "pops" if I were to let it go. Ive felt like Ive pulled the syringe a bunch and Im not getting any ink. its a brand new cartridge. anything I can do to...

So theres the 2 dampers going to the yellow print head. I almost ran out of one of the yellows I thought. But there is only air in what i believe is the cartridge that ran out. Ive pulled the damper off and tried to suck the air through but I continue to get just air. it is a 10ml syringe. will...

Would anyone be able to send me a service manual for my xc 540? Thanks info@xtremegraphicstint.com

i did change the color management setting to signs and displays.i dont think it would make that much of a difference....but who knows

today here in michigan it was quite a bit warmer than what it was when i printed the 2nd time with it turning out perfect with the heat settings higher. with the same heat settings today it resulted what is above. so i adjusted the heat settings lower than what they were the 2nd time and now the...

so i adjusted the heat settings and it printed perfect. then the company wanted me to reprint some of the sign material with white font instead of black. now im getting blurry edges.

im using the ICC profile that Oracal provided. its oracal 3641. what profile would you suggest? or would you keep the profile and just adjust the pre heat and print heat temp? They were at 35.

I'm using CorelDraw 12 with CYMK pallet. I export the file as an EPS to versaworks on my roland soljet pro III xc540. I'm making a basic sign with a colored background but with black boxes around the text and black text. There seems to be almost like an outline of white around the black...

I am using the versaworks 5.51 (the most current version). We are not trying to match graphics. Its going to be a complete wrap (he's running for state rep). I have a roland soljet pro III xc540, Enduralam 64" Cold Laminator.

ok. I appreciate the responses. Just to verify the best color format is RGB rather than PMS/CYMK? (roland xc540) And the graphic designer wants to know if I am able to use an adobe Illustrator CC file (or will I have to convert it)? Thanks again for the help. Raymond

Im just getting into the graphics industry and have a customer that needs his rv wrapped. The graphic designer wants a template if I can supply one or something close. I found one at the link below however I feel that the $300 is a lot to invest for potentially one template. Anyone know where I...