Search results

Not familiar with spicers that you mention...I am not concerned with the white laminate adhesive as much as the adhesive of the clear. In my experience...I had some "water-based" adhesive that had this same issue. I would check specs on the adhesive that is on the clear. Make sure that it is a...

What clear vinyl did you use What white vinyl did you use

Only changed the bad one...used Multi Meter...plus there are led lights that were not on so it was obvious which one was bad...

Grabbed a replacement thru digital media warehouse...spoke with Phil first, very informative. Also spoke with Brendon for processing order. I picked up this part from them...changed out curing unit for this same error, back to printing. The service and knowledge from them was top notch.

Got a t160 usb dont need...we needed ethernet..got new one to compensate...

201 for calenderd for indoor never outdoor...their new cast films for outdoor..although we use 3M 180 consistently for outdoor

Oracle liners are way to thin!!!!!..been that way for years hence why we do not use the films....step up oracal, Get on board...however you want to put it. Tried them...Curls on every product

Colex. You we wont be sorry.

Metamerism...color profiling for gray balance helps

I agree..done that as well...it works... Also if gloss laminated use the finest grit steel wool and rub all reg marks

I have 3 1624x...1 1604 before...out of service now...no problems...but mutoh..if your listening...this should be addressed...as I do not think a 4th is in the future from reading this...not good news from a printer that has been so reliable since the 1604...not impressed

Definitely not advising as it is a super safety issue if you are in close proximity during operation....although we have ours disabled for the very same reason...you need a volt meter/ tester to jump out or close the circuit. If you have reserve...consult electrician.... Remove bars and you are...

We had the CET flatbed and hybrid....the hybrid used the spectra 15pl heads...I always kept 2 on hand for a just in case moment... I never used them. Want to contact me...not sure if we are suppose to promote/sell on the forum...advise if ok... pics attached see if this helps....one in box from...

I have 2 spectra heads unopened

Buy er25 1/2" collet...I have colex and use one

Oh I should say the machine prints great when you baby sit it...just all that incumpuses the machine is ridiculous...from loading media,, recognizing media, warm up, then print...omg....extreme amount of time...and lord forbid if you don't run out 3 feet of material to get it started, look for a...

Sorry but on our third HP...and with all that has to do with these machines.(way to much to discuss...if you have one you know)..humm..this is our last HP printer...

You have the auto load option on

I have noticed...the blade in the holder is a compression hold...i have seen it just drop during cutting...I thought maybe a different tolerance of blades...I ended up putting extra emphasis on using the white nylon insertion tool and really pushing hard when installing a new blade...I know it's...

This is the MOST accurate post I can get on board with...exact same experience in its entirety... I cannot even add to it...3M..once thought of as the go to is now...hummh. They have no personal responses for anyone...mostly thinking the greed example is the best route they are taking...contact...