Search results

Thanks for the help guys, the DB9 6/8 to DB25 20 seems to have fixed it. I can now run the whole length of the plotter and not stopping until done. Thanks again, greatly appreciated.

Thanks I will try it again. The schematic only has 5 connections required and I checked the board and it matched.

Hi, Yes it is still alive. With some info I found online, I tried a few wiring combinations. I could get it to cut but I'm getting buffer overflow and ask to check the handshake. I can't use parallel anymore it's rare nowadays. I'm using a USB to serial cable and it's verified to work on an old...

Hi, I'm wondering if anyone happens to have the pinout of the serial cable DB9 to DB25 cable for Roland CJ-70 and doesn't mind sharing. The printing is old and dead but vinyl cutting is still functional. If I could only figure out the pinout for the handshake it will be golden. Attached is the...

I PM'd you. Thanks.

Thanks, I've seen those, I was hoping for something specific to 1100. I'll check the pdf again.

Hello, Can anyone point me in the right direction for the user manual (and/or service manual) for pnc-1100. I just got this old clunker that seems to be showing signs of life, it might still be worth checking it out. I have to mention that I've been scouring the net, but no luck. TIA.

thanks for the help guys, I just wanted to know how to use the control panel on the cutter. I read somewhere about settings on pressure and I need the manual for that. Is there a Graphtec model with similar control with available user manual? thanks again.

Hi, I have purchase a used Graphtec FC3100-100 cutter on ebay, I test plot with SignGo demo using a pen and it seems to be working. Does anyone know where I could find a user manual for it? I'm kinda a newbie to cutting plotter and I thought it would be good a cutter to start with. Thanks Mhel®

Thanks, I'm actually shelling a couple of hundred bucks, on exactly the same model, but not sure if it's functional or not. The description just says it powers up. But the tinkerer in me, thinks I could make it work.

thanks for reply.

Hi, I'm new to everything vinyl/cutter/plotter and just researching at this stage. I found an auction on ebay...