I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
The instructions that I had didn't say what initialize parameters meant. I looked up the section in [4-2 HOW TO UPGRADE/INSTALL FIRMWARE], and it shows the buttons to do this. It allowed me to choose VP-540. After that everything went smoothly. Thank you all for the responses and help.
Just to give an update. I ordered board from signs in china. It was delivered pretty fast. Installed it and all is working great. Thanks for the help with peck.
The dip switches were all either on or off like my board.
What do you mean by initialize the printer? I set ip and uploaded firmware. I can't do anything else because of this error. Sort of go into service mode, but as soon as I am in, this error locks it out.
Thanks
I have replaced the main board on the VP540 and have uploaded the flash. When in comes on it says Roland DGA and then unknown under it. I am assuming that it is because I have not uploaded parameters yet. Right after that, it says "turn power on again" If I use arroes, it shows error 0011...
I know this is about a year old. I have a few questions about this process. Can I trust Signs in China? How do I use Peck? Somebody sent me V 6.8. I am able to Get Report, but I am not able to Get Parameters. It just sits there with a progress bar that doesn't move. Am I doing something wrong or...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.