I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Also, which spoiler are you running? That’s also very important as well as speeds and feed. We can remote in with ya and confirm your settings are the news v8
Downcut 530 bit, we carry bits and blades that do a better job but the 530 is the stock bit that comes with the machine and is used for dibond and aluminum really up to .040. I can send you a bits breakdown if needed or refer you to our partner whom had a wide variety of bits, blades and spoiler...
T00502 is the. 6mm bit for polished acrylic, run it with .015 as your final pass depth. On your specific machine you don’t have a true polishing pass. It’s just a cleanup pass. See settings below or shoot me a text and I’ll remote in and walk you though it
Remove set screw on Teflon collar
Loosen set screw at the shaft end
Please knife in spine side facing center.
Tighten.
Replace spring and Teflon, setting screw in the little groove on side of tool. Tighten screw till it just touches then back off 1/2 turn to allow it to slide up and down...
I have the current settings from opti 8 and all their bits if you need some guidance one of our techs can remote in and walk you through some advanced setup
To everyone recommending cyclone attachment.. the issue with that is it’s not designed to run pvc in large volume, the static and heat build up will
Degrade the lines on the cutter. You’ll see holes start to form along the vac lines.
The high capacity rigid vacuum now come with larger tanks. You...
532 is not the proper bjt for this application on the colex. You’ll want to use the 4mm 530. The other option is to use a downcut bit to force the enamel down vs pulling it up with a standard up it.
We train, service and support colex cutters should you need any information regarding your...
False. The angle is set to low and the blade will make smaller cuts to avoid breakage. The head will lift up and down hundreds of times, it will make the cut eventually especially with single edge universal:
Depending on 7 or 8 opti will make the difference. .125 on all corner compensation will eliminate your overcut, in 7 it will not.
We move, install and service colex brand cutters all over the world. Ask us anything about opti.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.