I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Hi all,
Got a CJV150 we've had for about 3 months and every time I do a Print & Cut job the X origin seems to be out. Y doesn't seem to vary. I've run the P&C Origin Adjust several times and often have to re-run it after the next job I send cuts out of the print... I'm only setting the 720dpi...
Have a HP L26500 using Flexi 10 Firmware updated several months ago to 12, since then cannot read poll size from printer and the job prints short vertically anywhere from 1/2in to as much as 3''. HP tells me I have RIP and print problem SAi says I have a printer problem. Adjust size in the...
I'm in the process of trying to do print and cut graphics for a customer on chrome media. I've had issues with ARMS detecting the registration marks, but I've gotten it to work a few times by putting scotch tape over them. However, after the register "successfully", the cuts are WAY off. See...
Hi!
Im completly new in LFP, after preparing a used JV33-260 (new printinghead, new ink), I run into troubles after adjusting the head.
Printing with RasterLink is working, but printing in bidirectonal mode causes ghosting - a difference between the two ways about one millimeter. (see...
print head out of alignment
my prints are very fuzzy. it looks like i am getting the same results every time i print. the bands (when i turn print color bands) are overlapping when i do each print. no matter how many times i do printADJUST. they don't clear up. can you give me any advice as...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.