• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

air bubbles

  1. VJ 1324x air in cyan line only - one bad channel

    Hey there! First time posting and I have a questions regarding my Mutoh. I have one bad cyan channel on my valuejet that is causing me issues. I have done multiple head soaks and countless cleanings and am currently flushing the cyan line with cleaning solution. On the test print every other...
  2. Suggestions Bubbles in PET Film Installed 2nd Surface

    Hello. I just can't figure out how to avoid getting air bubbles with this media. I've tried water, water/soap. Using a more flexible squeegee seems to help but not entirely. I would rather not have to spend time popping the bubbles. I feel like a thinner film would lay down better but cannot...
  3. Seal 62 ProS Help

    Over the last few months or so, our laminator has decided to start leaving a line the whole width of the roll and if we don't pay attention it will ruin the print by leaving a bubble line all the way across our prints. Before, it only happened if the laminator sat for more than 30 minutes or so...
  4. Need Help Valuejet 1624X ink not flowing

    Hi! So ink is no longer moving through the tubes. There are air bubbles in Magenta, but none of the others, that I can see. However, when I run cleans, short or long, no ink is coming through the waste tubes from any of the colours. The ink does come out of the print head to perform a...
  5. HELP! VS 640 not working - missing colors

    Hello, I'm new in this fantastic forum, so I'm not sure whether I'm writing in the correct place. I've signed up to try and find a solution to a big problem I have with my Roland VS 640. I hope someone out there will be so kind as to help me. It all started with a banning in blue and red...
  6. Air bubbles

    Hi every0ne, i am getting a problem when i apply the vinyl onto foamex and some other surfaces, the only differnece is that i am not laminateing it, i leave the print to dry at least 24hrs before applying, i use a very small and thin needle to burst the air bubbles only to find they appear in...
Top