I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Hi,
I have been using Kiian's HI-PRO ink recently on a JV-300 and since then I have a bubble problem that forms on the captop during a long print. The ink seems very easy to lather.
Bubbles that form on the captop cling to the head and produce spots and lines on the print.
Has anyone had this...
On a Mutoh ValueJet 1614E machine the nozzle check for one side of black ink was not perfect. I had a clogged nozzle from some time and I tried to unclog it. I pulled some cleaning liquid through the nozzles. Gentle, without pushing hard until all the jets were clean and parallel. I mounted the...
Got in a situation where I needed to complete a dozen 48x96 fully coverage graphics on PolyMetal by myself. I got it done, but man it sucked. Prints were laminated 3M Print Film 40C.
I used a large Big Squeegee, but that was less than ideal. Since it is an air egrees film, I was able to work...
One of the yellows keeps dropping out randomly while printing. At first, I assumed it was caused by air in the lines somewhere. So I syringed it and it would work for a time and then drop out again. I then replaced both the yellow dampers. Problem still happened. I just tried swapping the...
Aloha,
Anyone got a Zund G3? We're installing one next week and we just learned that the air requirements are 10.5 CFM (minimum) and would like to know what others are using for air compressors. Thank you in advance for your time and help!
Bradley
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.