• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

cable

  1. Need Help Overriding Errors on Designjet l26500?

    So the waste management cable broke in the back of the printer (the metal connectors snapped off one another and one piece lost), and the cost is about $500 to replace and we are getting a new printer in like a week :/ the censor isn't necessary, is there anyway to get around that error message...

  2. Need Help Cable for a Roland 1410

    Does anyone know where I can get a printer cable for a Roland 1410 to a Mac. Its Usb to parallel (male) 36 pin port on the Roland side. Roland told me the don't make the cable any more. There is a serial port on the Roland, I have never used it, I been told it is for PC only. Any help would be...

  3. Question Summa D750 set up (WinPlot&Corel)

    Hi all, Tried for a while to set up my Summa D750 with WinPlot and CorelDraw X6. Everithing went fine until I tried to export the vector from Corel into WinPlot for cutting. I use a serial cable with a USB adapter for my laptop which has no serial port. When trying to send to cut I get the...
    • GTArt
    • Thread
    • Replies: 14
    • Forum: Summa

  4. Anagraph 60E on Widows 7 connected via series to USB cable

    Advice requested I have recently purchased Vinylmaster to go with my Windoiws 7 Dell 64 bit computer on which I have a serial to USB transfer cable When I press cut the vinyl scrolls back and forth approximately 4 ft before cutting at about a third of the selected font size Grateful for...

  5. Not connected

    I have a VP 540 printer, I notice that when I print a colored print the machine will stop on 4 or 5 passes an will say, Not connected. But when I just do a cut job it runs fine. I have change the IP address on the machine and on my laptop when it comes to printing. I am connect with a cable, no...
  6.

    Turnbuckle failure after 7 months.

    Had two over the street banners, 30in x 50ft, across 100ft of road. City had telephone type poles installed just for the project. Spec'd the cable and all the equipment based off of wind load calculations. Ordered everything through one supplier based off their recommendations for the job. The...
  7.

    Cant figure this out ink on connection cable again!

    I have a brand new black print head ~VP540i Roland~installed 8 months ago- but after 2 months; it was acting out with a lot of misfires. I called a tech out and he ordered a new connection cable...(I don't know what its called but the picture is attached!) It had black ink on one end (see...
Top