cjv

Hi there, We are happy to introduce MikaChip V2.0 - BS4 Mimaki ink emulator board. MikaChip V2.0 is ultimate ink chip replacement solution for those looking to switch from original ink to OEM ink. The ink emulator board allows to replace original Mimaki BS4 ink chips. It works in same way as...

Hello everybody, We have a problem on our Mimaki CJV150-160 machine. the Y belt does not have a direct line, it goes up the side of the pulley when the carriage is running. you would have a clearer explanation by looking at the pictures. kindly please help me solve the problem.

Hello, for three days I have had the same problem. I tried all the cleaning modes as well as the nozzles wash for 5 and 20 minutes. I also noticed an incorrect alignment on the MAGENTA. Please help me. Mimaki CJV150-160

Hello all, I am troubled. We had some fuzziness on a print yesterday. I figure it was from static. My boss suggested running a nozzle check, just to make sure. it was not good. We had quite a few missing pieces. No big chunks but a few here and here all over the print. So I ran a cleaning. Now...

Which one is the better deal? What are the main differences between the 2 in terms of tech.

So I was printing some vinyl and decided to switch over to some banner material. After switching to banner material, I received "ERROR 202 DEVICE CONSTRUCTION". In my google research, I was advise to turn off the Mimaki and turn back on to see if the error would go away. Well it didn't, but...

Hi, I could really need some help :) Bought a Mimaki CJV30-100 beginning of this year and this have been fun, printing things for clients like wallpaper, small contour cut stickers, doorstickers, windowstickers and some other things. But now I have small visible line in my prints. Can't find...

Our Mimaki CJV30-130 will not print & cut. We can print only just fine and we can cut only just fine however, if we do a cut after immediate print or print with reg marks and come back to cut it says "error" in Rasterlink Pro 5 SG. It does not give me a code it just says error in the status...

Hey everyone, first time caller / long time listener here... I was previously on a Versacamm SP540v and just had a brand new Mimaki CJV33-160 installed at our shop yesterday... I am having the following issue: After printing (oracal 3164, no overlam, 54") as the machine begins to contour cut...