I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I'm trying to figure out if there is a way to offset crop marks in Onyx. I see how to set edge marks, but I need the marks to generate inside the bleed so I know where to trim.
Trying to do a large run of reverse printed static cling decals, print/cut. Printed on xj540 and trying to cut on gx500. We have done this job before with good results, but the plotter won't find the back set of crop marks this time. Only difference from the last time we did this job is we...
So I'm making hard hat decals. They're printing beautifully. The machine switches to cut mode, reads the crop marks, then proceeds to cut all the decals out one cm too high and 1 cm too far to the left. Hmmm...
I've checked my pointer offset. It's fine. I'm using RasterLink Pro 5 SG, and up...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.