• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

gr-540

  1. Print and contour cut on VS and then perf cut on GR. How to manage nested jobs properly

    Hello Looking for a piece of workflow advice. I am using VersaWorks with a VS-300i and now with GR-420 as well connected to the same PC/VW. I have a proprietary SW which generates PDF files that I print (using nested jobs) and contour cut in VW with VS-300i. I plan to remove the printed and...
  2.

    Buffer Issues / Jumping in GR-540

    I have a GR-540, printing with cropmarks from a VS-540i. No issues between the two for the most part. When the GR is cutting complex jobs, the GR will pause for a couple of seconds then start again losing its place. My feeling is the buffer was full, stops to reload, then jumps. The move is...
    • KH
    • Thread
    • Replies: 4
    • Forum: Roland
Top