• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

happen

  1. VG540 Cutting problems. The printer heads are not staying in the capping area

    Using VW dual to do the job The printer will print out the job and then go back into the capping station Then the cutter and the heads will come out to cut the job. It causing a motor error to happen during the job Has this happen to anyone?
  2.

    Font Help Font ID

    Would anyone happen to know what font this is?
  3.

    Issue with L260

    Anyone ever seen this happen? Over the past couple weeks I have started to see this, just the first few inches of the print. This one went on for much longer....I can't tell what it is....Is part of the heater getting too hot? This has happened on multiple materials, and doesn't happen all the...

  4. Temp vinyl posters falling down

    I installed some non-perm adhisive posters on drywall in a gym. After two weeks one of the posters fell down. This is a large chain so I'm assuming this doesnt happen all the time. Is there a special way to install them? I used a felt squgee and tried to get the edges real good. Should I...
  5.

    Font help please

    Would anyone happen to know what font this is?
Top