I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Mimaki JV3-160sp (60in) solvent printer. $3500 or reasonable offer. The printer was bought 8yrs ago from a small sign shop in rural Kentucky, seeing a minimal amount of print work. It was like new when I bought it. I have a seasonal race car graphics business, so the printer is used steady for...
My JV3-160SP Main Board finally crapped out.
I replaced it with a new one, however, the new main board has a different firmware.
The new main board has the firmware: JV3-250SP v7.10 / MRL-II2
When I boot up the printer I get the following message: "Confirm AMF"
My JV3-160SP does not have a AMF...
Folks,
We have a mimaki jv3-160sp.
We had rasterlink pro III, but our rip station's hard drive died.
We have rasterlink pro II with the original install media and the dongle.
When we reinstalled, we found we didn't have the upgrade from II to III.
Mimaki no longer offers the upgrade...
Any suggestions would be greatly appreciated! I have a Mimaki Jv3-160s. I had to change a damper on it yesterday and also while I was there I changed two of the ribbon cables that connect to the print heads. Anyway, when I fired the machine back up, I got a display message that stated error...
Hi,
I bought a used mimaki JV3-160SP. This machine didn't come with docs, but I downloaded PDF operations and maintenance manuals.
I've been printing on 54" media and I'm considering doing a particular job on 60" media. JV3-160SP_Operation_Manual_V1.5.pdf says the maximum media width is...
Our Mimaki has this annoying issue of not registering when our cyan ink cartridge is empty. So we have to constantly keep an eye on the ink level via our RIP software and preemptively switch out for a new ink cartridge when we get down to 2% otherwise the printer will just keep plotting away...
Hello
I'm having issues with a JV3-160 SP. It way oversprays cyan at first then after a while oversprays about 50% less but enough to ruin anything with cyan in it and half of the cyan test print comes out slanted and jagged and seems to have some deflection. The head and dampers have been...
Ripping Flexi 7 to Production Manager.
Mid-print, JV3 will stop running and move from REMOTE to LOCAL.
Am I looking at a RAM issue or something in the printer? This issue is not consistent.
Also, at times, when adjusting quantities in Production Manager the JV3 will produce a few number of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.