I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Hi,
I have a Roland CJ-500 that won't cut anything only prints. When I do a demo print it works fine but when I try a Demo Cut the cutting carriage starts and then immediately stops because of a motor error which doesn't throw any code or anything (just says motor error). I also reset the Motor...
Purchased a used Rolland Cutter GX Camm1 having issue of not cutting after sending data to Production Manager, gives the White Port Error.. what am I suppose to look for??
Hi,
I was having problems cutting into my print which is Substance motocross Vinyl and Substance motocross laminate using the Graphtec FC8000. I gave Graphtec a call and they said I needed a different blade and said I need a 30 degree CB15U-K30 blade and the holder to suit which cost me £122...
Once a job is sent from Flexi to the plotter it feeds out all of the material and never cuts. It does not stop at the end of the material but rather spits it out. I have cleaned the sensors, checked connections, performed test cuts from the menu, and doe an overall cleaning. Any suggestions?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.