I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
We are in the market for a substrate cutter and I am looking for recommendations. Ideally, this machine would cut ACM, coroplast, foamcore, PVC and maybe a few other materials. I have a done a little research and found the FSC Multi-Material Cutter and the Foster SteelTrak (aka Keencut?)...
I want a machine that can rip 8ft sheets of ACM, polymetal or diebond, etc. other than the venerable table saw. Rarely use anything thicker than the 3mm. Along with coro, foamboad, sintra.
I have been considering the 98" Keencut steeltrak. In looking at some earlier posts there was a note...
One of our big name customers is requesting 18x24 building signs out of brushed aluminum composite. Ive noticed that our slitter leaves a ridge on each side where it cuts. Any advice on how to decrease/eliminate this?
FYI- We have a Fletcher Substrate Cutter.
Also keep in mind that a new...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.