• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

summa s2 t160

  1. Summa S2 T160 - Mind of its own

    We're having an issue with our Summa S2 T160 where it continuously plots a file ( we'll call it "File A") without being prompted for copies. Weirder still, if I try outputting a completely different file (we'll call it "File B") it will starting plotting File A again after File B is completed...
    • Shawnski
    • Thread
    • summa s2 t160
    • Replies: 3
    • Forum: Vinyl

  2. summa s2 t160 - leaving vinyl "shavings"

    Hey there, I had to change the blade in my summa s2 t160 and I thought I had it tuned in a cutting well, now it is leavings what I would call vinyl shavings in the cut and not cutting corners crisp, I used a clean cut 60 degree blade cutting oracal 651, i have never had this issue before on this...
    • ml4cs
    • Thread
    • summa summa s2 t160
    • Replies: 4
    • Forum: Summa

  3. Flexi Cutting Issues after upgrade to FX21

    So, I upgraded to Flexi 21 from 19 and can't figure this out. My print/cuts on Opus and Opus Extra mode for some reason comes out 15/16" off the actual cut path. Flexi Tech support can't even figure it out they blame summa lol?. I upgraded on my cutter the firmware to the latest. Printer is a...
    • imprezwrapz
    • Thread
    • cutcontours cutpaths flexi hp365 offcentered cuts printcuts summa summa s2 t160
    • Replies: 1
    • Forum: Flexi

  4. Summa S2 T160 always cutting FlexCut

    Hi! Our Summa S2 T160 suddently started cutting everything as FlexCut. We haven't changed anything in our setup, and the Summa hasn't been reconfigured in any way. But still, everything is cut with 15 mm flexcut. This is extremely annoying and why does it do this all of a sudden? We use...

  5. Need Help Summa S2 T160 CutContour and Flexcut problem with adhesive

    I am having an issue with the blade depth on our Summa S2 T160. The job I am trying to setup would be CutContour and then FlexCut with about 1/4" of backer exposed around the sticker (after weeded). The problem I am having is when I set the blade depth to work with the CutContour I cannot get...

  6. Need Help Summa S2 Class 160T OPOS Camera keeps stopping

    Hello there, Any time I am trying to plot large jobs (Usually under 200" long) whenever the OPOS cam reads the registration marks, sometimes it will work all the way around, and sometimes the camera stops halfway through, especially when the plot is sitting directly right on top of the...
    • Tasha
    • Thread
    • Replies: 3
    • Forum: Summa

  7. S2 T160 Helpful Tips

    We upgraded our XC-540 cutter to a Summa S2 T160. We were using an XC-540 for the cutting and it was limited in many ways due to accuracy and length of cuts for what we needed at this time. It's fun to learn new interfaces and setup procedures. I took the ol' out of the box, plug it in and...
Top