Need Help Cutting Strip

[archerdesign]

Hi...Im still running my old girl...My Roland Camm-1 PNC -1100 and she's in need of an 1/8th inch cutting strip. Anyone seen any around? All three of my suppliers dont carry it anymore. Thanks!

 

[crny1]

Pretty sure this would work. only a tenth of a mm smaller.

https://www.amazon.com/Cutting-Plot...=8-1-fkmr1&keywords=1/8"+roland+cutting+strip

 

[sardocs]

Put a strip of sandblast stencil film on there. That's a trick I learned in Roberts Creek 20 years ago.

 

[archerdesign]

Pretty sure this would work. only a tenth of a mm smaller.

https://www.amazon.com/Cutting-Plotter-Protection-Roland-Graphtec/dp/B01DP2H8CM/ref=sr_1_fkmr1_1?ie=UTF8&qid=1529366036&sr=8-1-fkmr1&keywords=1/8"+roland+cutting+strip

Thank you so much!

 

[archerdesign]

Put a strip of sandblast stencil film on there. That's a trick I learned in Roberts Creek 20 years ago.

Brilliant! I'll give that a shot. Thanks!

 

[archerdesign]

Put a strip of sandblast stencil film on there. That's a trick I learned in Roberts Creek 20 years ago.

Brilliant! I'll give that a shot. Thanks!

Did you put the Sandblast stencil film on top of your old cutting strip or did you remove the old one, and replace it with the sandblast film?